Securitron iEXD-24 Manuel d'utilisateur télécharger pdf

Securitron Magnalock Corp. Tel 775.355.5625

550 Vista Boulevard Fax 775.355.5633

Sparks, NV 89434 [email protected]

www.securitron.com

Page 1 Rev. D, 10/07

ASSA ABLOY, the global leader

in door opening solutions

MODEL iMXD-12, iMXD-24, iEXD-12, iEXD-24 INTEGRATED EXIT DELAY

SYSTEM INSTALLATION AND OPERATING INSTRUCTIONS

1. DESCRIPTION

Securitron’s iMXD is an integrated delayed exit locking system intended for use on emergency

exit doors. The iMXD fully meets American and Canadian building codes for delayed exit

(Special Locking Arrangements). The iMXD employs Securitron’s patented door movement

initiation to begin the delayed exit sequence and it permits the retention of existing fire

rated or non fire rated mechanical exit hardware on the door.

FIG. 1: iMXD OVERVIEW

Briefly, the iMXD functions as follows: The door's normal condition is secure from an

electromagnetic lock (model 62 series) within the iMXD housing. A person desiring to exit

attempts to use the door. The iMXD permits the exit door to move a short distance only (it

remains secure) and this door movement is internally detected. Movement detection leads to

the activation of an irreversible delay of 15 or 30 seconds. During this release delay period, a

Sonalert in the housing sounds and a remote alarm signal also activates. At the end of the

delay, the Sonalert stops and the lock releases. It remains released until manually relocked

(reset). In some code versions, relocking is accomplished by a momentary turn of an integral

keyswitch furnished as part of the iMXD housing. Other code versions mandate the use of door

position sensing so that reset is accomplished by the act of opening the door. The iMXD

incorporates door position sensing and it can be set for relocking via keyswitch or door position

sensing. Note that separate versions of the iMXD are supplied for 12 or 24 volt

operation.

Note that the iMXD typically is not combined with controlled entry from the outside (via a

card reader or digital keypad, for instance.) The reason is as follows: For the iMXD to work

properly, the door must include a mechanical latch which can’t be operated from the outside. A

person exiting, operates the latch by turning a handle or pushing an exit bar and this starts the

Model 62 Magnet Body

Green/Red Led's

Integral Keyswitch

Internal Sonalert

Strike Plate

Permanent Magnet Assy

Control Board

Mounting Sub-Plate

Wiring

Terminals

Gap Adjustment

Large phillips driver

Small phillips driver

3/16 hex wrench

1/8 hex wrench (provided)

Adjustable wrench

Wire stripers

Multi meter

RECOMMENDED TOOLS

1 2 3 4 5 6 ... 14 15

Résumé du contenu

Page 1

Securitron Magnalock Corp. Tel 775.355.5625 550 Vista Boulevard Fax 775.355.5633 Sparks, NV 89434 [email protected] www.securitron.com

Page 2 - Page 2 Rev. D, 10/07

PN# 500-18900 Page 10 Rev. D, 10/07 relocking. Attempt to relock it by either turning the keyswitch or opening the door (depending on the rel

Page 3 - Page 3 Rev. D, 10/07

PN# 500-18900 Page 11 Rev. D, 10/07 wishes to use the keyswitch for Relocking but not for Bypass or for Bypass but not for relocking, remove o

Page 4 - Page 4 Rev. D, 10/07

PN# 500-18900 Page 12 Rev. D, 10/07 6.1 POWER SUPPLY CONNECTIONS Figure 6 shows power supply connections for Securitron's 1 Amp units an

Page 5 - Page 5 Rev. D, 10/07

PN# 500-18900 Page 13 Rev. D, 10/07 FIG. 6: POWER SUPPLY AND FIRE ALARM CONNECTIONS R2R1B+B-F1FAP4P3P2P1COMMON NEGATIVEDC RETURN (0 VOLT)HOT

Page 6 - Page 6 Rev. D, 10/07

PN# 500-18900 Page 14 Rev. D, 10/07 CONNECTIONS FOR POWER SUPPLY USING CCS-8 BOARDR2R1B+B-F1FAR8R7R6R5COMMON NEGATIVEDC RETURN (0 VOLT)HOT NEU

Page 7 - FOR MAGNET

PN# 500-18900 Page 15 Rev. D, 10/07 MAGNACARE® LIMITED LIFETIME WARRANTY SECURITRON MAGNALOCK CORPORATION warrants that it will replace a

Page 8 - Page 8 Rev. D, 10/07

PN# 500-18900 Page 2 Rev. D, 10/07 delay. If the latch was operable from the outside, delay could be initiated from the outside and this void

Page 9 - Page 9 Rev. D, 10/07

PN# 500-18900 Page 3 Rev. D, 10/07 other times. For more powerful monitoring, the iMXD includes a second “remote” alarm signal consisting of

Page 10 - Page 10 Rev. D, 10/07

PN# 500-18900 Page 4 Rev. D, 10/07 FUNCTION Nuisance Delay Release Delay Relocking Power NFPA 101 (NATIONAL FIRE PREVENTION ASSOCIATION LIFE

Page 11 - Page 11 Rev. D, 10/07

PN# 500-18900 Page 5 Rev. D, 10/07 MATRIX #1: Switch 2 Off; Switch 3 Off nuisance delay disabled MATRIX #2: Switch 2 On; Switch 3 Off: (

Page 12 - Page 12 Rev. D, 10/07

PN# 500-18900 Page 6 Rev. D, 10/07 Then allow the door to fully close (this will capture the template). You can then accurately punch your mo

Page 13 - 115 VAC INPUT

PN# 500-18900 Page 7 Rev. D, 10/07 3.5 MOUNTING THE SUB-PLATE Note that for packaging security, the magnet body is affixed to the sub-plate.

Page 14 - Page 14 Rev. D, 10/07

PN# 500-18900 Page 8 Rev. D, 10/07 cover mounts utilizing screws into the sub-plate (see the drawing to the right). Do not mount the cover ye

Page 15 - Page 15 Rev. D, 10/07

PN# 500-18900 Page 9 Rev. D, 10/07 4.3 MAINTAINED BYPASS “Maintained Bypass” means releasing the door for an extended period of time for free

Modèles reliés iEXD-12 | iMXD-24 | iMXD-12 |

Plus de documents pour Pour la maison Securitron iEXD-24

Voir le document Securitron iEXD-24 Manuel d'utilisateur

Securitron iEXD-24 Manuel d'utilisateur (1 pages)

Commentaires sur ces manuels

Pas de commentaire

Securitron iEXD-24 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Pour la maison Securitron iEXD-24. Securitron iEXD-24 User Manual Manuel d'utilisatio

Résumé du contenu

Modèles reliés iEXD-12 | iMXD-24 | iMXD-12 |

Plus de documents pour Pour la maison Securitron iEXD-24

Commentaires sur ces manuels

Produits connexes et manuels pour Pour la maison Securitron iEXD-24