Securitron Magnalock Corp. www.securitron.com Tel 800.624.5625 [email protected] © Copyright, 2014, all rights reserved
PN# 500-23310 Page 10 Rev. B 06/14 5. Metal Door Frame - Drill Mounting Holes: Note: If installing on a wood door frame, go to Step 7. Dril
PN# 500-23310 Page 11 Rev. B 06/14 7. Wood Door Frame – Drill Mounting Holes: Drill two (2) 3/16” diameter holes at bracket-mounting hole ma
PN# 500-23310 Page 12 Rev. B 06/14 Strike Installation 1. Close the door and place the template between the bracket spacers. Mark the strik
PN# 500-23310 Page 13 Rev. B 06/14 4. Install Roll Pins into Strike Plate: Remove the two (2) roll pins from the hardware packet. Insert a
PN# 500-23310 Page 14 Rev. B 06/14 Adjustments: 1. Assemble Lock to the Bracket and Adjust: Loosen the two screws securing the mounting brac
PN# 500-23310 Page 15 Rev. B 06/14 3. Drill Frame for Anchor Screws: Using the mounting bracket as a template, drill the four remaining hole
PN# 500-23310 Page 16 Rev. B 06/14 Final Installation: 1. Insert the top of the Magnalock chassis at the end of the mounting bracket. Slid
PN# 500-23310 Page 17 Rev. B 06/14 Final Wiring 1. Pull wires/cables through the wire feed-through hole(s) that are drilled in the frame. Al
PN# 500-23310 Page 18 Rev. B 06/14 3. Motion Detector Models: Models equipped with a motion detector have control features accessed by the DI
PN# 500-23310 Page 19 Rev. B 06/14 5. After installation and wiring have been completed, re-install the lock cover through the lock chassis u
PN# 500-23310 Page 2 Rev. B 06/14 Recommended Tools M380BDCX Specifications Mechanical Electrical Environmental (Recommended) Physical Size
PN# 500-23310 Page 20 Rev. B 06/14 Troubleshooting Guide: POSSIBLE ISSUES TROUBLESHOOTING TIPS No power or low power Confirm voltage and c
PN# 500-23310 Page 3 Rev. B 06/14 Magnalock Orientation The physical position of the camera or motion sensor (PIR) module may be reconfigure
PN# 500-23310 Page 4 Rev. B 06/14 To remove or install a module, compress the legs of the support bracket and slide the bracket in or out of
PN# 500-23310 Page 5 Rev. B 06/14 Magnalock Preparation 1. Using a Phillips screwdriver, remove the two (2) screws securing the cover as sh
PN# 500-23310 Page 6 Rev. B 06/14 Component Label Component Name Selection Position SW3 DIP Switch SW3.1: LED Enable Position 1 setting of
PN# 500-23310 Page 7 Rev. B 06/14 SW1 DIP Switch SW1.4: PIR Ambient Light Compensation Can be enabled with SW1.4 Ambient Light Compensatio
PN# 500-23310 Page 8 Rev. B 06/14 J8 Terminal Block 8 BondSTAT A 2-wire terminal block providing a contact in which (NO/NC) state change is
PN# 500-23310 Page 9 Rev. B 06/14 Magnalock Installation 1. CH1 Remove two (2) screws securing lock to mounting bracket and slide the bracket
Commentaires sur ces manuels