Securitron PowerJump_ICPT Manuel d'utilisateur Page 2

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 2
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 1
Securitron Magnalock Corp.
www.securitron.com
Tel 800.624.5625
ASSA ABLOY, the global leader
in door opening solutions
Securitron Magnalock Corp.
www.securitron.com
Tel 800.624.5625
ASSA ABLOY, the global leader
in door opening solutions
Page 2
© Copyright, 2012, all rights reserved
500-24025
Rev A, 11/12
Page 3
© Copyright, 2012, all rights reserved 500-24025
Rev A, 11/12
Step 3: Installing in a WOOD door or frame
Step 5: Voltage Selection and Wiring
Wood A: Carefully tap a chisel through the
template to score the finish. Pre-Drill (2)
mounting holes according to wood type.
Wood C: Cut relief for faceplate
using a chisel to a depth of 1/8”
Wood D: Drill a wiring channel for
connection to the device to be powered
Metal A: Drill (4) mounting tab holes with 1/4”
drill bit countersink with 82° bit
Metal B: Cut main pocket with rotary tool using a
metal cutting wheel or a metal cutting saw
Metal D: Install mounting tabs using (4) 10/32 screws.
Attach adhesive spacers as needed to mount the unit flush with the frame
Wood E: Test fit the unit into the
pocket and file if needed
Metal C: Test fit and file opening
b) Supply 24V DC power to frame unit. Connect purple wire to positive (+)
and black wire to (-). Connect door side electrified device via wiring channel,
connect red wire to (+) and black wire to (-)
12V / 24V
Powered
Latch
24V
Power
Supply
Purple (+)
Black (-)
Red (+)
Black (-)
Hard Wood: 3/32” bit, 3/4“ deep
Soft Wood: 1/16” bit, 2” deep
Tip: mark the auger
bit with tape at a
depth of 1 5/8”
Drill to this depth
Tip: For 18 gauge metal use
(2) of the included spacers
Step 4: Installing in a METAL door or frame
C
NO
Access Control
Frame
Unit
Door
Unit
(+)(+)
(-)
Wood B: Carefully drill out the pocket
with the auger bit, to a depth of 1 5/8”
Use a wood chisel to straighten the sides
Be careful not to damage the surface
Step 6: Mount PowerJump
Wood: Use (2)
#8 wood screws
Metal: Use (2)
8/32 machine screws
to mount to tabs
a) Select output voltage of 12V or 24V. Move the two jumpers as shown:
12V
output
24V
output
Hard Wood: 1” Screws
Soft Wood: 2 1/8” Screws
Vue de la page 1
1 2

Commentaires sur ces manuels

Pas de commentaire