Securitron EXD Manuel d'utilisateur Page 1

Securitron Magnalock Corp. www.securitron.com ASSA ABLOY, the global leader Tel 800.624.5625 [email protected] in door opening solution

PN# 500-13350 Page 10 Rev. E, 11/11 FIG. 4: POWER SUPPLY AND FIRE ALARM CONNECTIONS POWERSUPPLY 1 2 3CONNECTIONS FOR BPS-12-1OR BPS

PN# 500-13350 Page 11 Rev. E, 11/11 CONNECTIONS FOR POWER SUPPLY USING CCS-8 BOARDBATTERYPACK(OPTIONAL)+ACFUSEHNGF1FAF2HR1R5P1P2P3P4TERMINALS

PN# 500-13350 Page 12 Rev. E, 11/11 FIG. 5: CHART FOR SELECTION OF BATTERY PACK SIZE MIN 1 HR 2 HR4 HR8 HR 16 HR 24 HR 48 HR 72 HRUL STD.150 M

PN# 500-13350 Page 13 Rev. E, 11/11 based on the amount of current that may be supplied into a short circuit. An individual might receive a bu

PN# 500-13350 Page 14 Rev. E, 11/11 To implement lock status reporting, a “B” version Bondstat Magnalock should be employed. Tie the red and w

PN# 500-13350 Page 15 Rev. E, 11/11 7.3 FREE EGRESS FUNCTION The free egress function puts the XDT logic timer in a different operating mode.

PN# 500-13350 Page 2 Rev. E, 11/11 2.1 LOCKING DEVICE The full range of Securitron's model 62, 68, 82, 32, 38 and model SAM shear alignin

PN# 500-13350 Page 3 Rev. E, 11/11 The MXD is a kit which includes a housing that surrounds the magnet body and conceals a proximity switch arr

PN# 500-13350 Page 4 Rev. E, 11/11 Certain code versions require the use of a door switch to accomplish reset. You may select any door switch

PN# 500-13350 Page 5 Rev. E, 11/11 The XDT logic timer is the heart of any EXD system. The following drawing is an overview of the timer'

PN# 500-13350 Page 6 Rev. E, 11/11 4.2 STANDARD BUILDING CODE NUISANCE DELAY: Not allowed. RELEASE DELAY: 15 seconds or extension to 30 second

PN# 500-13350 Page 7 Rev. E, 11/11 Switch 1: This sets the amount of time for release delay. In the factory set (Off) position, release dela

PN# 500-13350 Page 8 Rev. E, 11/11 FIG 3: TYPICAL WIRING, EXD SYSTEM WITH MECHANICAL BAR, MXD, SB-MXD OR LATCH MONITOR LEDMKKEYSWITCHINITIATEDE

PN# 500-13350 Page 9 Rev. E, 11/11 shown in Figure 3 is used, the connection is simpler. +V from the power supply connects to COM of device #1