ASSA ABLOY, the global leader in door opening solutions © Copyright, 2011, all rights reserved PN# 500-22700 Rev. F, 03/11 SERIE
PN# 500-22700 Page 9 Rev. F, 03/11 Figure 12 – Double Door (No Access Control Unit) Fail secure electric locks are normally not permitted fo
PN# 500-22700 Page 10 Rev. F, 03/11 Figure 15 shows the installation of an MOV in parallel with the magnetic lock. An MOV is provided with ea
PN# 500-22700 Page 11 Rev. F, 03/11 Figure 16 This product was designed for use with Securitron Magnalocks. The Magnalock secures the door
PN# 500-22700 Page 12 Rev. F, 03/11 Make sure that the bar is installed with the plastic washers under the head of the mounting screws.
PN# 500-22700 Page 13 Rev. F, 03/11 4. Using a #1 Phillips screwdriver, back out the two (2) screws to release the base riser from the res
PN# 500-22700 Page 14 Rev. F, 03/11 3 INSTALL POWER CORD AND FLEXIBLE DOOR CORD SHIELD 1. Unroll the DSB power cord and feed the non-co
PN# 500-22700 Page 15 Rev. F, 03/11 4 REASSEMBLE END MOUNT ASSEMBLY IF the PC board and plunger slide out of the end mount: 1. Insert co
PN# 500-22700 Page 16 Rev. F, 03/11 10. MAGNACARE LIFETIME REPLACEMENT WARRANTY For warranty information visit: www.securitron.com/en/site/
Securitron Magnalock Corp. www.securitron.com ASSA ABLOY, the global leader Tel 800.624.5625 [email protected] in door opening solutions
PN# 500-22700 Page 2 Rev. F, 03/11 Fasteners for metal doors (aluminum frame and hollow steel) are included. For through door mounting please
PN# 500-22700 Page 3 Rev. F, 03/11 The bar is level. The bar is centered on the door (left to right) between the door frame stops. By
PN# 500-22700 Page 4 Rev. F, 03/11 6.2. HOLLOW METAL DOOR PREPARATION The bar should be mounted to the door using the blind nuts and screws p
PN# 500-22700 Page 5 Rev. F, 03/11 6.4. BOLT THROUGH DOOR PREPARATION: For through-bolt mounting on various door types a DSB-TDM kit will be
PN# 500-22700 Page 6 Rev. F, 03/11 e. Insert each end of the (spiral) conduit into the recess of each of the cord caps and mount each cap to
PN# 500-22700 Page 7 Rev. F, 03/11 i. Mark the bar to indicate the desired cut. Note: For a DSB with the illuminated sign option, the bar sh
PN# 500-22700 Page 8 Rev. F, 03/11 8. ELECTRICAL CONNECTIONS AND WIRING 8.1. DSB WIRING The DSB is supplied with either a 16-foot [4.88 mete
Commentaires sur ces manuels