Securitron Magnalock Corp. www.securitron.com Tel 800.624.5625 [email protected] © Copyright, 2012, all rights reserved
PN# 500-10550 Page 10 Rev. C, 08/12 4. Install Roll Pins into Strike Plate: Remove the two (2) roll pins from the hardware packet. Insert a
PN# 500-10550 Page 11 Rev. C, 08/12 Adjustments: 1. Assemble Lock to the Bracket and Adjust: Loosen the two screws securing the mounting bra
PN# 500-10550 Page 12 Rev. C, 08/12 3. Drill Frame for Anchor Screws: Using the mounting bracket as a template, drill the four remaining hol
PN# 500-10550 Page 13 Rev. C, 08/12 Final Installation: 1. Insert the top of the Magnalock chassis at the end of the mounting bracket. Sl
PN# 500-10550 Page 14 Rev. C, 08/12 Final Wiring 1. Pull wires/cables through the wire feed-through hole(s) that are drilled in the frame. A
PN# 500-10550 Page 15 Rev. C, 08/12 3. After installation and wiring have been completed, re-install the lock cover through the lock chassi
PN# 500-10550 Page 16 Rev. C, 08/12 Troubleshooting Guide: POSSIBLE ISSUES TROUBLESHOOTING TIPS No power or low power Confirm voltage an
PN# 500-10550 Page 2 Rev. C, 08/12 Recommended Tools M670 / M680BD Specifications Mechanical Electrical Environmental (Recommended) Physica
PN# 500-10550 Page 3 Rev. C, 08/12 Magnalock Preparation 1. Using a Phillips screwdriver, remove the two (2) screws securing the cover as s
PN# 500-10550 Page 4 Rev. C, 08/12 Component Label Component Name Selection Position JP1 Jumper 1: Tamper Switch Mode Select A 3-pin jumper
PN# 500-10550 Page 5 Rev. C, 08/12 J1 Terminal Block 1 Tamper Switch A 2-wire terminal block providing a SPDT contact that changes state as d
PN# 500-10550 Page 6 Rev. C, 08/12 Magnalock Installation 1. CH1 Remove three (3) screws securing lock to mounting bracket and slide the brac
PN# 500-10550 Page 7 Rev. C, 08/12 5. Metal Door Frame - Drill Mounting Holes: Note: If installing on a wood door frame, go to Step 7.
PN# 500-10550 Page 8 Rev. C, 08/12 7. Wood Door Frame – Drill Mounting Holes: Drill two (2) 3/16” diameter holes at bracket-mounting hole ma
PN# 500-10550 Page 9 Rev. C, 08/12 Bracket Spacers Strike Installation 1. Close the door and place the template between the bracket spacers.
Commentaires sur ces manuels